HARLEY DAVIDSON PREMIUM SUSPENSION KIT REMOVAL AND INSTALLATION MANUAL
download REMOVAL Front Fork Assembly 1. Refer to the XR model section of the service manual and remove the front forks. INSTALLATION Front Fork Assembly 1. Install front forks from kit to motorcycle...
View ArticleHARLEY-DAVIDSON SOFTAIL MODELS STEALTH AIR SHOCK MOUNTING
download INSTALLATION 1. Remove the seat, inner fender, and ignition coil cover. Removing the rear wheel assembly is recommended for ease of installation, but not absolutely necessary. Remove the nut...
View ArticleKTM Enduro Engineering Shock Spring Removal And Installation Instructions
download 1 Place motorcycle on a stand so that the rear wheel is off the ground. 2 Remove the upper shock bolt. (Figure 1) 3 Remove the lower shock bolt. (Figure 2) 4 Remove the shock from the...
View ArticleVespa GTS Super Specification
download Gts super 300 ie Gts super 125 ie s 125cc s 50cc Gts 250 ie Gts 125cc LX 125cc LX 50cc 2 stroke Engine Single-cylinder, catalised, QUASAR 4 stroke, 4 valve electronic injection Single-cylinder...
View ArticleHONDA 450E/ S MOUNTING AND ARS ADJUSTMENT INSTALLATION
download MULTI-RATE SPRINGS AND THE ARS SYSTEM Depending on the application dual–rate springs are fitted on the shocks. Dual-rate springs are just that– a spring set with two separate rates. This is...
View ArticleHARLEY DAVIDSON LOW REAR SHOCK KIT INSTALLATION MANUAL
download See Figure 3 and Table 1. INSTALLATION Shock Absorbers Perform this installation when the engine is cool. Working on or near the exhaust system when the engine is hot could result in severe...
View ArticleHONDA ST1100 SHOCK MOUNTING INSTALLATIOAN AND REMOVAL INSTRUCTIONS
download Works Performance Products, Inc. constructs two types of shocks for the ST1100. Both have an integral reservoir (often referred to as a “piggyback” reservoir). This reservoir increases the...
View ArticleHONDA GL1500CD/ VALKYRIE Specifications
download position when it comes to the environment. We continue to develop low-emission technologies for our current and future motorcycles, ATVs, scooters and personal watercraft. We already produce...
View ArticleHonda ST 1300 Series Single Shock Supplement
download Check the orientation of the adjuster on the shock body – looking at the top of the shock, the hydraulic line port should be165 degrees (clockwise) from the nitrogen pressure valve (see figure...
View ArticleATK 50MX INSTALLATION AND ADJUSTMENT TIPS
download PRELOAD ADJUSTMENT— On some Works shocks a threaded preload is standard. This allows the adjustment of the ride height of the motorcycle. The preload is changed by turning a threaded nut down...
View Article
